Discussion: Attention Deficit Hyperactivity Disorder
December 15, 2017
Mental Health Research Paper
December 15, 2017

Unit III assessment
Unit III Annoucement- Subpart G, H, and I
Last week we looked at Subparts D, E, and F of the OSHA Standards.  This week’s lesson we will look at the next three subparts: G, H, and I.
The Occupational Safety & Health Administration (OSHA) standards can be loosely divided into two categories: safety standards and health standards. The difference is that safety standards typically prevent injury through design specifications, and health standards prevent illness that may develop from long-term exposure to specific hazards.  In last week’s lesson, we focused on a few safety standards.  This week we will begin incorporating some health standards as well as some standards that combined both health and safety.
 
Subpart G covers Occupational Health and Environmental Controls.  This subpart refers to the workplace environment and covers issues such as ventilation, occupational noise control, and non-ionizing radiation.
Subpart H includes several complex safety/health issues that address the storage and handling of flammable materials, process safety management, and hazardous waste operations.
Subpart I is the use of personal protective equipment to protect employees from workplace hazards.  PPE should be considered the last line of defense.  As part of the update to subpart D, walking-working surfaces, OSHA has also included an update to subpart I (Fall Protection) into their final rule.  You will see changes to the fall protection portion of Subpart I when Subpart D is released.
I know we covered a lot of standards this week.  You do not need to be an expect in all of the standards, our focus for this course is to become familiar with what OSHA standards exist and how you can easily find them
Question 6

  1. For offhand grinding machines, what is the maximum permissible opening between the work rest and the abrasive wheel? Include the citation for the OSHA standard where you found the answer to the question.

Your response should be at least 75 words in length.
Question 7

  1. What is a Class I, Division II location? Include an example in your explanation. Include the citation for the OSHA standard where you found the answer to the question.

Your response should be at least 75 words in length.
Question 8

  1. What are the requirements for safe indoor storage of oxygen cylinders used in oxygen-fuel gas welding? Include the citation for the OSHA standard where you found the answer to the question.
 

"Is this question part of your assignment? We Can Help!"

Essay Writing Service